INSPECTION - TM-10-3930-638-24-P0613

TM 10-3930-638-24&P

3-13. STARTER AND SOLENOID REPAIR (cont)

REMARKS

ACTION

ITEM

STEP

LOCATION

DISASSEMBLY (cont)

WARNING

(cont)

Wear safety glasses when drying parts with compressed air. Fail-

ure to do so could cause serious injury to eyes and possible blind-

ness. [f you hurt your eyes or if a foreign object is blown into

your eyes, seek medical attention immediately.

Use clean cloth moistened with cleaning

All other parts

Clean

solvent P-D-680. Dry thoroughly with

compressed air

INSPECTION

Replace if cracked, crazed, distorted, or if

Inspect

Brushes (39)

brush wear exceeds one half of new brush

length

Inspect

Replace if cracked, worn or distorted, or if

Brush holder (37,

38)

brush does not move freely in holder

Brush springs (35)

Inspect

Inspect for wear, cracks, distortion or dis-

coloration. Check brush spring tension to

check that brushes are held firmly. If

tension is weak or if any other condition

is observed, replace spring

Inspect

Replace if worn, cracked, pitted or burred

Sleeve bearings (21, 34)

Inspect

Drive assembly (15)

Replace if worn, damaged, distorted, or

pinion teeth cracked, chipped, worn or

damaged, or pinion does-not turn freely

in over-running direction

Inspect

Armature (10)

Replace if cracked, worn, damaged or

distorted or commutator rough or out

of round

Inspect

Replace if cracked, worn, damaged or

Solenoid switch (24)

distorted

Inspect

Replace if worn, cracked, damaged or

All other parts

distorted

3-107