DISASSEMBLY - TM-10-3930-638-24-P0611

TM 10-3930-638-24&P

3-13. STARTER AND SOLENOID REPAIR (cont)

REMARKS

ACTION

ITEM

STEP

LOCATION

DISASSEMBLY (cont)

Remove and

a. Gasket (18)

Center bearing

discard

(20)

Remove and

b. Oil seal (19)

discard

NOTE

Do not remove sleeve bearing (21) unless replacement is required.

Remove

c. Sleeve bearing (21)

Remove

a. Two screws (22) and

Drive housing

lock washers (23)

(53)

Pull straight out from drive housing (53)

Remove

b. Solenoid switch (24)

From plunger (32)

Remove

c. Plunger spring (25)

Remove

d. Spring pin (26)

e. Nut (27)

Remove

f. Screw (28)

Remove

g. Two seal washers (29)

Remove

h. Shift lever (30)

Remove

i. Boot (31)

Remove

j. Plunger (32)

Remove

k. Pin (33)

NOTE

Do not remove sleeve bearing (34) unless replacement is required

as per inspection.

1. Sleeve bearing (34)

Remove

Release

a. Two brush springs

Field frame (7)

(35)

Remove

b. Two brush support

pins (36)

Remove

Remove as one assembly

c. Two brush holders

(37, 38), two brushes

(39), four screws

(40, 41), and two

brush springs (35)

Disconnect and

d. Two ground brush

and remove

leads (42)

e. Two screws (40)

Remove

f. Two screws (41)

Remove

g. Two brush holders

Disassemble

(37, 38), brushes (39)

and separate

and brush springs-

(35)

3-105