 |
|||
|
|
|||
|
Page Title:
ALTERNATOR REPAIR (cont) |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-12. ALTERNATOR REPAIR (cont)
ACTION
REMARKS
ITEM
LOCATION
STEP
REASSEMBLY (cont)
CAUTION
Do not overtighten vise. Overtightening may distort and damage
rotor.
Mount
In vise
17
Rotor (23)
a. Rotor (23)
Install
b. Drive end frame (1)
Install and
Tighten nut (24) hand tight only
c. Shaft collar (26),
tighten
lock washer (25)
and shaft nut (24)
18
Slip ring end
a. Slip ring end frame
Back up
Use camshaft gear remover tool on area
(2)
surrounding bearing recess
frame (2)
Install
Press on until bearing is flush with end
b. Roller bearing (22)
frame housing
c. Outer terminal stud
Position
insulator (20)
Install
d. Terminal stud (21)
e. Voltage regulator (19)
Position
f. Nut (18)
Install
Position
g. Brush holder (17)
Install
h. Screw (16)
i. Screw (15)
Install
Install
j. Two screws (14)
k. Inner terminal stud
Install
insulator (13)
l. Rectifier bridge
Install
assembly (12)
Install
m. Relay terminal (11)
n. Nut (10)
Install
o. Two screws (9)
Install
p. Diode trio (8)
Install
Install
q. Capacitor (7)
r. Two screws (6)
Install
s. Stator (4)
Install and
connect
CAUTION
Use care to not damage stator.
t. Three nuts (5)
Install
u. Drive end frame (1)
Position
Align positioning marks on frames (1, 2)
CAUTION
Use care not to damage rotor and stator. Do not use hammer to
install drive end frame in slip ring end frame. Hand push around
entire circumference.
3-100
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals