 |
|||
|
|
|||
|
Page Title:
Separation of Engine and Transmission |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
3-5. ENGINE MAINTENANCE (cont)
d. Separation of Engine and Transmission.
a. Removal of transmission from engine
This task covers:
b. Installation of transmission on engine
EQUIPMENT CONDITION
INITIAL SETUP
Paragraph
Condition Description
Power pack (engine/transmission)
TOOLS
NSN 5180-00-754-0641
removed from vehicle.
Automotive Mechanic's
Tool Kit
MATERIALS/PARTS
One 3/ 8-24 N F by 4 inches
guide stud
ITEM
REMARKS
ACTION
STEP
LOCATION
REMOVAL
To support transmission in upright
Transmission
1
Transmission supports
Install as shown
position after removal from engine
Engine flywheel
Remove
2
Support dust cover (4)
a. Three cap screws (1),
housing
lock washers (2) and
washers (3)
b. Dust cover (4)
Remove
c. Eight cap screws (5)
Loosen and
Reach in flywheel housing opening
and remove screws (5) securing flex
remove
plate to flywheel. Rotate flywheel
at crankshaft pulley as required, to
reach all eight cap screws. Hold
crankshaft pulley stationary (use
1 /2" drive wrench) while removing
cap screws (5).
To transmission
a. Sling and hoist
3.
Transmission
Connect
b. Ten-cap screws (7) and Remove
Support transmission with hoist
lock washers (8)
From left side of transmission
c. Two nuts (6) and lock
Remove
washers (8)
Slide rearward from flywheel housing
d. Transmission
Remove
until flex plate clears housing, then
lift and remove
NOTE
Remove studs (9) only if required for replacement.
3-46
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals