Power Pack (cont). - TM-10-3930-638-24-P0551

TM 10-3930-638-24&P

3-5. ENGINE MAINTENANCE (cont)

c. Power Pack (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

REMOVAL (cont)

Engine, rear

NOTE

Perform the following steps only if rear engine mount (12)

requires replacement.

Loosen and

Support engine mount (I 2)

a. Four nuts (9), lock

remove

washers (10) and cap

screws (11)

Remove

b. Engine mount (12)

INSTALLATION

Position

a. Rear engine mount

Engine, rear

(12)

Tighten to 150-180 ft. lb. torque.

Install and

b. Four cap sinews (11),

lock washers (10) and

tighten

nuts (9)

Engine compart-

ment

WARNING

Keep clear of engine and transmission during power pack

installation. Never place hands or body under power pack.

Failure to do so may cause serious injury or death due to

power pack falling.

CAUTION

Check that all hoses, lines and wires are clear as power pack is

slowly lowered into vehicle. If necessary, reposition hoses, lines

or wires before installing power pack.

Slowly lower and Into rear chassis, with mounting holes

a. Power pack

install

aligned

Position

b. Two transmission

mounts (15)

c . Eight washers (14) and Install

cap screws (13)

d. Rubber motor mounts (16) Install

Install

e. Washer (8) and cap

screw (7)

Washers (6 and 5) and Install and

Until bottom of rubber engine mount (16)

tighten

expands to same diameter as washer (6)

new lock nut (4)

Install and

g. Two cap screws (3),

Until bottom of rubber mounts expand to

tighten

washers (2) and new

same diameter as washers (2)

lock nuts (1)

Change 1

3-45