Steering Cylinder Assembly (cont)

TM 10-3930-638-24&P

2-48. STEERING SYSTEM MAINTENANCE (cont)

c. Steering Cylinder Assembly (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

REMOVAL

NOTE

Removal of either steering cylinder assembly is the same.

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or

excessive heat and don't smoke when using it. Failure to do so

could cause serious injury. If you become dizzy while using

cleaning solvent, get fresh air immediately, and get medical

attention. If contact with skin or clothes is made, flush with large

amounts of water. If contact with eyes is made, wash eyes with

water immediately, and obtain medical aid immediately.

Side of vehicle a. Steering cylinder

Clean

Use cleaning solvent P-D-680

assembly - ( 12) and

hydraulic connections

Remove

b. Tie strap (1)

Loosen and

c. Two hose clamps (2)

remove

Remove

d. Steering cylinder

guard (3)

Prevents intrusion of dirt

e. Hose fitting (4)

Disconnect and

plug

f. Elbow (5)

Remove and plug

Prevents intrusion of dirt

opening in

cylinder ( 12)

Disconnect and

Prevents intrusion of dirt

g. Hose fitting (6)

plug

h. Elbow (7)

Prevents intrusion of dirt

Remove and plug

i. Steering cylinder

Support with

chain hoist, or

assembly (12)

jack stand or

appropriate

block

Remove

j. Retaining ring (8)

k. Pin (9)

Remove

l . Retaining ring (10)

Remove

m. Pin (11)

Remove to clean

n. Steering cylinder

work area

assembly (12)

Change 2 2-340