 |
|||
|
|
|||
|
Page Title:
Front Drive Shaft Assembly and Support Bearing |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)
a. Front Drive Shaft Assembly and Support Bearing (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
SERVICING
Use clean cloth and remove dirt and
a. Clean
Lubrication fitting
1
Drive shaft
grease
support
Refer to current lubrication order;
b. Lubricate
bearing (9)
lubricate until grease oozes out of
bearing
CAUTION
Don't use a high pressure grease gun to apply lubricant to lubrication
fitting (14). Use of a high pressure grease gun will cause seals
to rupture.
Use clean cloth and remove dirt and
a. Clean
Universal joint
Lubrication fitting (14
2
grease
(17) and yoke (4) and (13)
Refer to current lubrication order;
b. Lubricate
lubricate until grease oozes out of fitting
REMOVAL
Para 2-39b, step 2
a. Center drive shaft
Disconnect from
3
Drive shaft
front drive shaft
support bearing
yoke (4)
Remove
b. Cotter pin (1)
Remove
c. Nut (2) and washer (3)
Use puller
d. Yoke (4)
Remove
e. Four nuts (5), lock
Remove
washers (6), and cap
screws (7)
f. Two setscrews (8)
Remove
Remove
g. Drive shaft support
bearing (9)
Remove
a. Four cap screws (11)
4
Front axle
b. Front drive shaft
Remove by moving
differential
towards rear,
assembly (12)
companion yoke
dropping it down-
ward and pulling
forward
Remove
c. Collar (10)
DISASSEMBLY
Remove
Lubrication fitting (13)
Yoke (4)
5
a. Lubrication fitting (14) Remove
Front drive shaft
6
b. Four nuts ( 15) and cap Remove
assembly
screws (16)
Remove
c. Universal joint (17)
2-235
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals