 |
|||
|
|
|||
|
Page Title:
Transmission Linkage Controls (cont). |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
2-38. TRANSMISSION MAINTENANCE (cont)
b. Transmission Linkage Controls (cont).
ITEM
ACTION
REMARKS
LOCATION
STEP
CLEANING
Use clean diesel fuel. Dry thoroughly
Clean
8
Cables (53, 54) and con-
trol lever balls (16, 23)
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don't breathe vapors. Do not use near open flame or exces-
sive heat and don't smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immed-
iately, and obtain medical aid immediately.
Use cleaning solvent P-D-680. Dry
Clean
9
All other parts
thoroughly
INSPECTION/REPAIR
Replace if cracked, worn, damaged,
Inspect
Cables (53, 54)
10
twisted or distorted
Replace if cracked, worn, damaged,
Inspect
11
Spring (10)
distorted or permanently set
12
Replace if cracked, worn, damaged,
Inspect
All other parts
distorted, or missing or damaged threads
INSTALLATION/REPLACEMENT
Position
a. Two cables (53, 54)
13
Operator's com-
Install
b. Two tie straps (52)
partment, under
Position
c. Two cable clamps (51)
floor panel
Position
d. Two cable hold down
plates (50)
Install
e. Three spacers (47)
Position
f. Clamp (49)
Position
g. Washer (55)
Install
h. Four cap screws (48)
i. Four lock washers (46)
Install
Install
j. Four nuts (45)
Position
a. Cable bracket (44)
Transmission
14
Position
b. Two lock washers (43)
Install
c. Two cap screws (42)
Install
d. Stud (41)
Position
e. Spacer (40)
2-217
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals