 |
|||
|
|
|||
|
Page Title:
START Switch and VEHICLE LIGHTS Switch (cont). |
|
||
| ||||||||||
|
|
 TM 10-3930-638-24&P
2-28. INSTRUMENT PANEL MAINTENANCE (cont)
b. START Switch and VEHICLE LIGHTS Switch (cont).
REMARKS
ITEM
ACTION
LOCATION
STEP
CLEANING (cont)
4
Clean
All hardware
Use cleaning solvent P-D-680.
Dry thoroughly with compressed air
INSPECTION
5
Rubber boot (2)
Inspect
Replace if threads damaged, or if boot
cracked or deteriorated
6
Harness and START
Replace if insulation frayed, or if
Inspect
SWITCH wires
conductors broken
7
Switches (3 and 14)
Replace if threads or terminals damaged
Inspect
8
Terminal blades (7)
Replace if broken or corroded
Inspect
9
Inspect
All hard ware
Replace if worn, or if threads damaged
INSTALLATION
Instrument panel, a. VEHICLE LIGHTS
10
Position
In instrument panel
left of steering
switch (14)
b. Four screws (12) and
column
Install and
Until VEHICLE LIGHTS switch (14) is
securely mounted
tighten
lock washers (13)
c. Three levers (11)
Position
On shafts of VEHICLE LIGHTS
switch (14)
Install and
d. Three screws (9) and
Until levers (11) are securely mounted
tighten
and lock washers (10)
Install and
e. Harness connector (8)
On VEHICLE LIGHTS switch (14)
tighten
f. Hex nut (4)
Install and
For l/8 inch of START switch threads
above instrument panel
position
On START switch (3)
Install and
g. Two screws (5),
washers (6) and
tighten
terminals (7)
h. START switch (3)
Position
In instrument panel
i. Rubber boot (2)
Until START switch (3) is securely
Install and
tighten
mounted
j . Wire leads (1)
Push on
To terminals (7)
k. Wire leads (1),
Seal
Use silicone rubber sealer
terminals (7) and
harness connector (8)
2-132
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals