Section Ill. OPERATION UNDER USUAL CONDITIONS

TM 10-3930-638-10

Section Ill. OPERATION UNDER USUAL CONDITIONS

Para

Operating Instructions on Decals

Initial Checks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-8

and Instruction Plates. . . . . . . . . . . . . . . . . . . . . . . . 2-11

Operating Procedures . . . . . . . . . . . . . . . . . . . . . . . . 2-9

Preparation for Movement . . . . . . . . . . . . . . . . . . . 2-10

(2) Mount truck and sit in operator's seat.

2-8. INITIAL CHECKS

(3) If necessary, adjust seat by moving lever to rear

to release seat for adjustment and move seat

Refer to current Lubrication Order and lubricate fork-

forward or backward.

lift truck. Refer to paragraph 2-7 and perform before

(4) Fasten seat belt.

operation PMCS.

2-9. OPERATING PROCEDURES

a. Starting the Engine.

WARNING

Noise level exceeds 85 dB(A) at three feet

in front, 15 feet at side and 24 feet at rear

of vehicle. All personnel shall wear a

hearing protection device when operating

the vehicle.

WARNING

(5) Pull parking brake lever towards you to act

parking brake.

Before starting engine, check and be sure

that STEERING BYPASS valve is closed

(fully clockwise) and that shipping lock pin

has , been removed. Failure to do so will

cause loss of steering control which may

result in serious injury or death and

damage to equipment.

(1) Remove shipping lock pin by slipping ring of

klik pin down from body of shipping lock pin

then removing klik pin. Remove shipping lock

pin from chassis, install klik pin and store

shipping lock pin under operator's seat.

(6) Place transmission DIRECTION SELEC-

TOR in neutral (N) position.

(7) Insert key into ignition switch; turn key to first

position clockwise (ON position).