MAST ASSEMBLY - TM-10-3930-638-100020

TM 10-3930-638-10

PINTLE HOOK. Manually operated latch type rigid

1-15. BODY, TOWING ATTACHMENTS,

pintle. Opened by removing cotter pin, pulling latch

AND TOWING CONTROLS (cont)

handle rearward, and lifting top jaw. Accepts standard

3 inch by 1-5/8 inch lunette for connecting towed load to

forklift truck.

ROLL OVER PROTECTIVE STRUCTURE. Constructed

of heavy duty steel; bolted to front chassis. Protects

CHAINS. Steel link construction with attachment hooks;

operator from injury due to falling material and truck

provide additional connection (safety) between forklift

rolling over.

truck and towed load or towing vehicle.

SIDE PANELS. Constructed of sheet metal; secured to

STEERING BYPASS VALVE. Mounted on left side of

rear chassis with latches. Provide access to engine

operator's seat; turning valve handle counterclockwise

compartment.

disables steering system and allows front chassis to pivot

freely about rear chassis and steering cylinders. Valve

RADIATOR GRILLE. Welded steel construction;

must be open when towing forklift truck, and must be

protects engine radiator, transmission oil cooler, and

closed (turned fully clockwise) for normal steering and

vehicle lights from damage. Swings open for access to

truck operation.

batteries and radiator overflow bottle.

AXLE DISCONNECT LEVER. Used to disengage axles

WARNING

from transmission when towing forklift truck to new

location. Pulling lever outward allows transmission

The tow bar is provided to tow the

output shaft to freewheel, and prevent transmission

forklift ONLY.

damage or wear while towing. Lever must be pushed

TOW BAR. Constructed of heavy duty steel; normally

inward for normal truck operation.

stowed in vertical position with retaining pin. Pivots to

horizontal position to connect forklift truck to towing

vehicle.

ROTATE CONTROL LEVER. Hold in forward position

MAST. Raises and lowers carriage. Hydraulic lift cylinder,

to rotate forks counterclockwise; hold in rearmost position

controlled by LIFT control lever, raises and lowers two

to rotate forks clockwise.

lift chains attached to carriage. Two hydraulic tilt

cylinders, activated by TILT control lever, tilt mast

LIFT CONTROL LEVER. Hold in forward position to

forward or rearward.

lower carriage and forks; hold in rearmost position to

raise carriage and forks.

FORKS. Constructed of heavy duty steel; mounted on

carriage. Locking notches on carriage and locking lugs on

SHIFT CONTROL LEVER. Hold in forward position to

forks permit adjustment of width between forks.

shift forks to left; hold in rearmost position to side

shift forks to right.

CARRIAGE. Rotates and side shifts forks. Hydraulic

TILT CONTROL LEVER. Hold in forward position to

rotation cylinder controlled by ROTATE control lever;

tilt mast and forks forward; hold in rearmost position to

hydraulic side shift cylinder controlled by SHIFT control

tilt mast and forks rearward.

lever.

Change 1

1-10