|
|
TM 10-3930-638-10
1-10. FUEL SYSTEM (cont)
AIR CLEANER INDICATOR. Indicates restriction of
air flow through air cleaner due to dirty or clogged filter
QUICK START CONTROL. Used to start engine in cold
element. Filter element service is required when red signal
weather. When lever is pressed against valve, injects
within indicator is in full view. After servicing filter
volatile starting fuel from steel cylinder to engine.
element, indicator is reset by depressing button on top
Removable clip attaches to lever to prevent accidental
of indicator.
discharge.
a. Vehicle Lights.
area in front of vehicle for driving forward and material
VEHICLE LIGHTS SWITCH. Contains three separate
handling. Turned on and off with FRONT FLOOD
switch sections used to control all vehicle lights. Also has
switch.
internal resistance to provide selection of dim illumination
of gage lights. Ignition switch must be turned to extreme
REAR FLOOD LIGHTS. Two sealed-beam type lamps
left or ON position for VEHICLE LIGHTS switch to
mounted on bottom of steel plates behind radiator grille.
operate.
Illuminate area behind vehicle for backing up, connecting
FRONT FLOOD AND REAR FLOOD SWITCHES.
tow bar, or connecting towed load. Turned on and off
with REAR FLOOD switch.
Used to independently turn front and rear flood lights on
and off. VEHICLE LIGHTS main switch section must be
in SER. DRIVE position for these switches to operate.
SERVICE STOP AND TAIL LIGHTS. Two light
assemblies mounted on top of steel plates behind radiator
BLACK OUT DRIVING LIGHTS. Mounted at left side
grille. Assembly includes incandescent lamp and red
of roll over protective structure. Provides forward black
plastic lens. Tail lights turned on and off with VEHICLE
out illumination during tactical operations. Controlled
LIGHTS switch. Stop lights are normally off; turned on
by VEHICLE LIGHTS switch.
by depressing service brake pedal.
GAGE LIGHTS. Internal lights illuminate meter face
BLACK OUT STOP AND TAIL LIGHTS. Two light
and pointer of FUEL and OIL PRESS gages. Bright,
assemblies mounted in protective metal housings at rear
dim and off settings controlled by VEHICLE LIGHTS
of vehicle. Each assembly contains two incandescent
switch.
lamps. Provides stop light and tail light illumination
during tactical operations. Tail lights turned on and off
FRONT FLOOD LIGHTS. Four sealed-beam type
with VEHICLE LIGHTS switch. Stop lights are
lamps mounted on roll over protective structure and
normally off; turned on by depressing service brake pedal.
steel channel extension of instrument panel. Illuminate
1-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |