Reassembly - TM-10-3930-634-340177

TM 10-3930-634-34

and lockwasher; lockwire to prevent loosening.

one notch at a time and follow with opposite nut until

(5) Install carrier housing (101) to axle housing.

correct backlash is obtained.

(6) Reassemble axle assembly in reverse order of

(b) If backlash is under minimum specification,

disassembly.

back off nut on flange half and tighten nut on opposite

NOTE

side. Operation should be done in one notch steps until

Torque all bolts and screws to torque as speci-

correct backlash is obtained.

fied in paragraph 1-7b(8).

(c) Tighten carrier cap bolts to specified torque

e. Installation. Refer to paragraph 2-8 and install

(see torque chart). Recheck backlash. If backlash is not

the axle assembly.

within limits, repeat above procedure to correct. In-

stall bearing adjusting nut locks and secure with screw