Section VI. MAINTENANCE OF LUBRICATION SYSTEM

TM 10-3930-634-12

Table 4-2.

Section VI. MAINTENANCE OF LUBRICATION SYSTEM

4-12. General

This section contains information on maintenance of

the lubrication system, including oil filter lines and

dipstick.

4-13. Oil Filter

a. Removal. Remove the right engine side panel for

access to the oil filter. Refer to figure 4-1 and remove

the oil filter.

b. Cleaning and Inspection.

(1) Refer to figure 4-2 to service the oil filter.

Remove center stud and disassemble filter as shown.

(2) Make sure gasket surface is free from old

gasket material. Clean with an approved cleaning sol-

vent and dry thoroughly.

(3) Inspect cover and mounting flange for nicks

and cracks. Remove small nicks with fine sandpaper.

c. Installation. Use new gaskets, O-ring and filter

element upon reassembly. Refer to figure 4-1, and

reinstall four mounting screws to install oil filter.

CAUTION

Check for oil leaks when engine is start-

ed. Oil leaks may cause serious damage to

the engine.

TA031840

Figure 4-1. Oil filter, removal and installation.

4-4