 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-632-34
l.
Remove plug (8). Remove plug seal (9) and
Remove screw (4), nut (5), and lockwasher (6). Pry arm
(9) off of shaft (25).
pull valve spring (10) and ball (11) out of hole.
m.
Disassemble and remove regulator valve (15)
KEY to figure 14-6:
by removing plug (16), washer (17), valve spring (18),
1.
Capscrew
regulator piston (19) and valve stop (20). Drive pin (22)
2.
Lockwasher
out of hole and pull valve body (21) out. Remove washer
3.
Selector arm
(23) and seal (24).
4.
Capscrew
n.
Remove screws (4 and 3) and remove cover
5.
Nut
plate (6).
Remove and discard gasket (12) and
6.
Lockwasher
preformed packings (13 and 14).
7.
Cotter pin
o.
Attach a suitable puller and remove drive gear
8.
Clevis pin
9.
Valve arm
(25). Remove screws (26) and pull stator support (27)
10.
Retaining ring
from position.
11.
Washer
p.
Expand and remove retaining ring (32).
12.
Oil seal
Remove shaft washer (33) and driven gear (34) from
13.
Neutral start switch
shaft of oil pump (35). Remove capscrews (36 and 37)
14.
Washer
and lockwashers (38 and 39). Remove retainer plate
15.
Actuator pin
(40) and oil pump (35).
16.
Bleeder valve
q.
Remove seals (44, 42 and 43) from converter
17.
Pipe plug
housing (50).
18.
Reducer bushing
19.
Bushing seal
r.
Remove oil seals (28), shims (29), locating
20.
Balance spring
ring (30) and bearing (31) from main gear and shaft (41).
21.
Expander cup
s.
Disassemble the control valve (29, fig. 14-2)
22.
Sealing cup
as follows:
23.
Valve piston
(1) Remove capscrew (1, figure 14-6) and
24.
Return spring
lockwasher (2). Pry selector arm (3) off of shaft (29).
25.
Arm and shaft
(2) Remove cotter pin (7) and clevis pin (8).
26.
Spacer
27.
Cotter pin
28.
Clevis pin
29.
Arm and shaft
30.
Control cover
31.
Bushing
14-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals