Section VII. HYDRAULIC OIL TANK

TM 10-3930-632-34

cracks or broken weldments. Replace damaged parts.

Inspect all parts of the carriage assembly for

WARNING

rust, chipped paint, or other damage; remove any rust

and paint the entire assembly.

Dry cleaning solvent, P-D-680, used to clean

Check the rollers for binding operating, cracks

parts is potentially dangerous to personnel and

in the seals, or other damage; replace damaged rollers.

property. Avoid repeated and prolonged skin

Discard any damaged cotter pins or other pins.

contact.

Do not use near open flame or

excessive heat. Flash point of solvent is 100 F

- 138 F. (39 C. - 59 C.).

4-32.

Reassembly

Refer to figure 4-7 and reassemble the carriage, lift

4-31.

Cleaning and Inspection

chains, and rollers.

Wipe the rollers with a cloth dampened with

4-33.

Installation

cleaning solvent P-D-680. Clean all other parts with

cleaning solvent P-D-680.

Lubricate the chains

Install the carriage and chains (para 2-6a).

thoroughly with light engine oil.

Inspect all parts of the carriage assembly for

distortion, cracks, breaks, or other damage. Weld

Section VII. HYDRAULIC OIL TANK

4-34.

General

4-36.

Repair

The hydraulic system oil supply tank is integral with

a. Repair cracks or other minor damage by first

the fork lift frame. The tank therefore cannot be

removed as a unit for repair.

draining all fuel and hydraulic oil from the fork lift truck.

b. Weld cracks or damaged areas to restore

original finish.

4-35.

Inspection

Check the hydraulic oil tank for cracks and damages.

4-13