Section VIII. OVERHEAD GUARD AND FLOOR PLATE

TM 10-3930-632-12

b. Secondary Suppression Components. These

components have radio interference suppression

functions which are incidental or secondary to their

primary functions.

4-14. Replacement of Suppression Components

Refer to figure 4-1 and replace the radio interference

suppression components.

4-15. Testing of Radio Interference Suppression

Components

Test the capacitors for leaks and shorts on a capacitor

tester; replace defective capacitors. If test equipment is

not available and interference is indicated, isolate the

cause of interference by the trial-and-error method of

replacing each capacitor in turn until the cause of

interference is located and eliminated.

Figure 4-1. Interference Suppression Components,

Removal and Installation, Sheet 2

Section VIII. OVERHEAD GUARD AND FLOOR PLATE

4-16. General

guard periodically to insure good condition and security

of mounting hardware.

An overhead guard is provided to protect the lift truck

b. Removal. Remove the overhead guard as

operator from falling objects. It is imperative that the

shown in figure 4-2. Remove the mounting hardware

guard be installed on the truck and in good condition at

and lift the overhead guard off of the lift truck.

all times.

4-17. Overhead Guard

a. Inspection. Visually inspect the overhead

4-15