Stopping - TM-10-3930-632-120017

TM 10-3930-632-12

Figure 2-1. Driving Controls and Instruments

2-3.

Stopping

a. Refer to figure 2-2 and to the following

(5) Operate load lift control lever forward

to lower forks to ground.

procedures for stopping the truck.

(6)

Turn starter and ignition to OFF

(1) If truck is in motion, remove foot from

position.

accelerator and apply gradual pressure to brake pedal to

NOTE

stop truck.

If engine has been running hard, it is good

(2) Apply parking brake by pulling up

practice to operate the engine at fast idle for

lever.

several minutes without load to allow engine

(3) Shift direction shift lever to N (neutral)

heat to dissipate, preventing engine parts from

position.

warping when it is shut down.

(4) Operate load tilt control lever to bring

upright to vertical position.

2-2