Disassembly. - TM-10-3930-631-340104

TM 10-3930-631-34

d. Assembly.

(4) Remove screws (8), lock washers (9),

washers (10) and nuts (11).

(1) Install thermal relays (7, fig.

7-24) on

(5) Loosen hose clamps and disconnect hose

reservoir and secure with nuts (4), lock washers (5) and

(6, fig. 7-23). Loosen hose clamps and disconnect

washers (6).

hoses (2 and 16, fig. 5-8) from reservoir.

(2) Install new gasket (15) on reservoir and

(6) Carefully lift reservoir (12, fig. 7-24) from

install cover (14). Secure cover with nuts (13).

truck.

(3) Install inlet screen (3) and gage (1). Install

b. Disassembly.

new breather (2) on reservoir.

e. Installation.

(1) Remove breather (2, fig. 7-24), gage (1)

and inlet screen (3) from reservoir.

(1) Install reservoir in truck and secure with

(2) Remove nuts (13) and remove cleanout

screws (8), lock washers (9), washers (10) and nuts (11).

cover (14) and gasket (15) from top of reservoir.

Install drain plug (16).

(3) Remove nuts (4), lock washers (5), washers

(2) Connect hoses (2 and 16, fig. 5-8) to

(6) and thermal relays (7) from reservoir.

reservoir and tighten clamps.

c. Cleaning, Inspection and Repair.

(3) Connect suction hose (6, fig. 7-23) to

(1) Replace breather after 200 hours of

reservoir and tighten clamp.

operation.

(4) Refer to TM10-3930-631-12 and fill hydraulic

(2) Clean inlet screen in cleaning compound,

reservoir.

solvent (Fed. Spec. P-D-680) and dry thoroughly.

(5) Operate truck and bleed hydraulic lift

(3) Flush the inside of the reservoir with solvent

cylinders (para. 7-7). Replenish oil as necessary.

and allow to dry thoroughly.

(6) Install floor and toe plates and drip pan.

(4) Inspect reservoir for evidence of leakage.

Check welds for cracks and damage.

Repair if

necessary.

7-37