Section IV. HYDRAULIC RESERVOIR

TM 10-3930-630-34

Section IV. HYDRAULIC RESERVOIR

welding is possible, flush tank thoroughly to remove all

3-13. Description

traces of explosive solvents, both liquid and vapor.

The hydraulic reservoir is mounted on the right side of

Weld per recommended specification (para 2-10).

the frame. Hydraulic oil is stored in the reservoir for use

in the hydraulic system. The reservoir is of welded steel

NOTE

construction.

Reservoir must be thoroughly

3-14.

Hydraulic

Reservoir,

Removal

and

cleaned and flushed after repair.

Disassembly

c. Inspect all parts for ,damage and replace

a. Removal. Refer to TM 10-3930-630-12 and

as authorized. If tank damage is beyond reasonable

remove the hydraulic reservoir.

welding repair, replace tank.

b. Disassembly. Disassemble the hydraulic

d. Clean breather and gage screen reverse

reservoir in numerical sequence as illustrated in figure

flow of hydraulic fluid or compressed air

3-5.

3-16.

Hydraulic Reservoir,

Reassembly

and

3-15.

Hydraulic Reservoir, Cleaning, Inspection

Installation

and Repair

a. Reassembly. Reassemble the hydraulic

a. Flush reservoir (10, fig. 3-5) with cleaning

reservoir in the reverse numerical sequence as

compound, solvent (Fed. Spec. P-D-680). Dry

illustrated in figure 3-5.

thoroughly with compressed air.

b. Installation. Refer to, TM 10-3930-630-12

b. Inspect tank for rust, cracked seams or

to install the hydraulic reservoir and bleed the hydraulic

damaged threads. If damage is such that repair by

system.

3-7