APPENDIX C BASIC ISSUE ITEMS LIST, ITEMS TROOP INSTALLED OR AUTHORIZED LIST

TM 10-393-630-12

APPENDIX C

BASIC ISSUE ITEMS LIST, ITEMS TROOP

INSTALLED OR AUTHORIZED LIST

Section I. INTRODUCTION

C-1.

Scope

Code Explanation

X2 - Repair parts which are not stocked and have no

This appendix lists basic issue items and items troop

foreseen mortality. The indicated maintenance

installed or authorized required by crew/operator for

category requiring such repair parts will attempt to

operation and required for the performance of

obtain the parts through cannibalization or

organizational maintenance of the fork lift truck.

salvage. The item may be requisitioned, with

exception data, from the end item manager for

C-2.

General

immediate use.

This Basic Issue Items, Items Troop Installed or

G - Major assemblies that are procured with PEMA funds

Authorized List is divided into the following sections:

for initial issue only as exchange assemblies at DS

a. Basic Issue Items List-Section II. A list, in

and GS level These assemblies will not be stocked

alphabetical sequence, of items which are furnished

above DS and GS level or returned to depot supply

level

with, and which must be turned in with, the end item.

NOTE

b. Items Troop Installed Or Authorized List-Section

III. A list, in alphabetical sequence, of items which, at

Cannibalization or salvage may be used

as a source of supply for any items source

the discretion of the unit commander, may accompany

coded above except those coded X1.

the end item, but are not subject to be turned in with the

(2) Maintenance code. Indicates the lowest

end item.

category of maintenance authorized to install the listed

C-3.

Explanation of Columns

item. Capabilities of higher maintenance categories are

considered equal or better. Maintenance codes are:

The following provides an explanation of columns

Code

Explanation

found in the tabular listings.

a. Source, Maintenance, and Recoverability Codes

Crew/Operator

(SMR).

Organizational maintenance

(1) Source code. Indicates the source for the

(3) Recoverability code.

Indicates whether

unserviceable items should be returned for recovery or

listed items. Source codes are:

Code

Explanation

salvage.

Items not coded are nonrecoverable.

Recoverability codes are:

P-

Repair parts, supplied from the GSA/DSA or Army

Code

Explanation

supply system and authorized for use at indicated

maintenance categories.

Repair parts (assemblies and components) which are

P2 -

Repair parts which are procured and stocked for

considered economically reparable at direct and

insurance purposes because the combat or military

general support maintenance levels When the item

essentiality of the end item dictates that a

is no longer economically reparable, it is normally

minimum quantity be available in the supply

disposed of at the GS level When supply

system.

considerations dictate, some of these repair parts

P9 -

Assigned to items which are NSA design controlled:

may be listed for automatic return to supply for

unique repair parts, which are stocked and

depot level repair as set forth in AR 710-50. When

supplied by the Army COMSEC Logistic System

so listed, they will be replaced by supply on an

and which are not subject to the provisions of AR

380.4L

exchange basis.

M-

Repair parts which are not procured or stocked as

Repair parts and assemblies which are economically

such in the supply system but are to be

reparable at DS and GS activities and which

manufactured at indicated maintenance levels.

normally are furnished by supply on an exchange

A-

Assemblies which are not procured or stocked as

basis. When items are determined by a GSU to be

such but are made up of two or more units. Such

uneconomically reparable, they will be evacuated

component units carry individual stock numbers

to a depot for evaluation and analysis before final

and descriptions, are procured and stocked

disposition.

separately, and can be assembled to form the

High dollar value recoverable repair parts which are

required assembly at indicated maintenance

subject to special handling and are issued on an