Figure 4-43. Flywheel timing marks.

TM 10-3930-630-12

TA034818

Figure 4-43. Flywheel timing marks.

(3) Place thumb over spark plug hole and

their maximum opening. Gap should be 0.020 inch

crank engine until an outward pressure is felt through

(0.50 mm). Refer to b above to adjust gap.

hole.

(6) Tighten screw (12, fig. 441) to secure

(4) Continue cranking until "DC" mark (fig.

distributor in position. Check point gap to be certain it

443) on flywheel is aligned with timing pointer.

did not change.

(5) Loosen screw (12, fig. 441) securing

(7) Install dust seal rotor and distributor

distributor clamp. Slowly rotate distributor until breaker

cap on distributor.

point lever is at high point on cam. Points should be at

4-51