 |
|||
|
|
|||
|
Page Title:
Figure 2-1. Controls and instruments (sheet 1 of 2). |
|
||
| ||||||||||
|
|
 TM 10-3930-630-12
Figure 2-1. Controls and instruments (sheet 1 of 2).
CONTROLS
1.
PARKING BRAKE LEVER - PULL BACK ON LEVER TO APPLY PARKING BRAKE. MOVE LEVER
FORWARD TO RELEASE BRAKE.
2.
HORN BUTTON - DEPRESS BUTTON TO SOUND HORN.
3.
TRANSMISSION SHIFT LEVER - MOVE LEVER TO "F" POSITION TO MOVE TRUCK FORWARD. MOVE
LEVER TO "R" POSITION TO MOVE TRUCK TO REAR. POSITION LEVER IN "N" (NEUTRAL) WHEN
PARKING OR STARTING TRUCK.
4.
LIFT CONTROL LEVER - MOVE LEVER TO REAR TO LIFT FORKS. MOVE LEVER FORWARD TO
LOWER FORKS
5.
TILT CONTROL LEVER - MOVE LEVER FORWARD TO TILT MAST FORWARD. MOVE LEVER TO REAR
TO TILT MAST BACKWARD.
6.
STEERING WHEEL - ROTATE WHEEL IN DIRECTION DESIRED TO TURN TRUCK.
7.
ACCELERATOR - DEPRESS PEDAL TO INCREASE ENGINE SPEED. RELEASE PEDAL TO DECREASE
ENGINE SPEED.
8.
IGNITION SWITCH - ROTATE SWITCH TO RIGHT TO ACTUATE STARTER. RELEASE KEY TO ALLOW
TO RETURN TO RUN POSITION. ROTATE KEY TO LEFT TO HALT ENGINE OPERATION.
9.
SERVICE BRAKE PEDAL - DEPRESS PEDAL TO APPLY BRAKES AND STOP TRUCK.
10. INCHING CONTROL PEDAL - DEPRESS PEDAL TO SLOW TRANSMISSION SPEED AND ALLOW HIGH
ENGINE SPEED. GIVES OPERATOR PRECISE CONTROL FOR INCHING LOADS.
11. CHOKE CONTROL - PULL OUT TO CLOSE CHOKE VALVE DURING ENGINE START. PUSH ALL THE
WAY IN TO OPEN CHOKE FOR NORMAL OPERATION. 12.LIGHT SWITCH - PULL OUT TO TURN ON
LIGHTS.
12. LIGHTS SWITCH - PULL OUT TO TURN ON LIGHTS
INSTRUMENTS
1.
FUEL GAGE - INDICATES AMOUNT OF FUEL IN FUEL TANK.
2.
COOLANT TEMPERATURE GAGE - INDICATES OPERATING TEMPERATURE. NORMAL READING
SHOULD BE 160 TO 180F (71 TO 82C).
3.
AMMETER - INDICATES AMOUNT OF CURRENT FLOWING TO OR FROM BATTERY. SHOULD SHOW
HIGH RATE OF CHARGE AFTER STARTING AND TAPER DOWN TO NEAR CENTER OF DIAL AFTER
OPERATING A SHORT TIME.
4.
OIL PRESSURE GAGE - INDICATES WORKING OIL PRESSURE IN ENGINE. NORMAL OPERATION
SHOULD INDICATE IN RUNNING RANGE AT NORMAL OPERATING SPEED
5.
HOURMETER - OPERATES WHEN ENGINE IS RUNNING. RECORDS HOURS OF OPERATIONS.
6.
TRANSMISSION TEMPERATURE GAGE - INDICATES TEMPERATURE OF TRANSMISSION OIL.
NORMAL OPERATING TEMPERATURE SHOULD BE IN GREEN AREA.
7.
HYDRAULIC FILTER ELEMENT INDICATOR - INDICATES CONDITION OF FILTER ELEMENT. IF
INDICATING LINE REACHES RED ZONE, REPLACE ELEMENT.
TA034764
2-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals