Inspection and testing.

TM 10-3930-628-12

Figure 4-8. Battery service

b. Battery.

(b)

Inspect battery for cracks, breaks and other

(1) Removal.Open battery cover and remove

defects.

side panels. Raise seat to locked position to provide

clearance when removing battery from truck. Disconnect

gravity reading of the battery. A fully charged battery

battery receptacle (fig. 4-2). Attach a hoist of sufficient

should show a reading of approximately 1.275. If

capacity to lifting eyes on battery and lift battery and

reading is 1.125 or lower, recharge battery. Refer to TM

receptacle connector from the truck.

9-6140-200-15 for checking specific gravity of battery.

(2) Cleaning. Tighten all filler caps securely.

(d) Check electrolyte level and fill to 5% inch

Clean battery posts, cable terminals, and top of battery

above plates.

with a solution of baking soda and water. Use care to

(4) Installation. Connect hoist to battery (fig. 4-

prevent solution from entering filler caps and getting into

8) and lift battery into compartment. Connect removable

battery. After foaming from solution stops, flush battery

receptacle to lower receptacle and secure with lever.

with clean, fresh water.

Install side panels and close battery cover.

(3) Inspection and testing.

(a) Check cables for frayed insulation, broken

strands, and damaged terminals.

4-11