 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 (3)
Repair damaged painted areas.
4-51. Overhead Guard
Tighten or replace loose or missing hardware.
a. Removal (fig. 1-1 or 1-2). Remove overhead
c. Installation. Slide side panel into guide and
guard by removing four bolts, lockwashers, and nuts.
lower cover onto battery compartment. Tighten
b. Cleaning and Inspection.
bolts.
(1)
Clean with an approved cleaning
4-53. Floor Plates
solvent (Federal Specification P-D-680) and dry
a. Removal. Remove mounting screws and lift
thoroughly.
floor plate from truck.
(2) Inspect for cracks, breaks, bends, loose
b. Cleaning and Inspection.
or missing hardware, or other defects.
(3) Tighten or replace loose or missing
(1)
Clean with an approved cleaning
hardware.
solvent (Federal Specification P-D-680) and dry
c. Installation. Installation is the reverse of
thoroughly.
removal.
(2)
Inspect for breaks, cracks, dents,
distorted mounting holes, loose or missing hardware, or
4-52. Battery Compartment Cover
other defects.
a.
Removal.
Remove bolts (4) and
(3) Tighten or replace loose or missing
lockwashers, then lift the cover from the truck.
hardware. Replace a defective floor plate as necessary.
b. Cleaning and Inspection.
c. Installation. Installation is the reverse of
(1)
Clean with an approved cleaning
removal.
solvent (Federal Specification P-D-680) and dry
4-54. Static Drag Strap
thoroughly.
Inspect to verify that strap reaches ground. Replace by
(2) Inspect for breaks, cracks, dents, rust,
removing screw and washer and lifting from bottom of
damaged painted areas, loose or missing hardware, or
truck.
other defects.
4-30
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals