 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 1.
Tilt cylinder (2)
2.
Clevis (2)
3.
Pivot pin (4)
4.
Cotter pin (4)
5.
Clevis set screw (2)
6.
Hose (4)
7.
Steering gear adjustment locknut
Figure 4-14. Tilt cylinder
(1) Set mast to vertical position and lower
(4) Replace defective tilt cylinder.
c.
Installation. Installation is the reverse of
forks to ground.
(2)
Disconnect the hydraulic hose
removal.
assembly.
(3) Remove cotter pin and pin from each
(1) Adjust tilt cylinder piston rod clevis (2) as
end of the tilt cylinder.
required to obtain 3 degrees forward tilt in the mast and
b. Cleaning and Inspection.
10 degrees rearward tilt on the full rearward tilt.
(1) Clean with cloth dampened with an
(2) If excessive twisting of mast is noticed
approved cleaning solvent (Federal Specification P-D-
at full forward or rearward position, adjust rod clevis as
680) and dry thoroughly.
necessary for correction.
(2) Inspect for leaks, dents, cracks, loose
(3) Install pivot pins (3) and tighten set
or missing mounting hardware, or other defects.
screws (5).
(3) Replace missing hardware.
4-26
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals