Figure 4-28. Distributor timing adjustment.

(2) Advance the flywheel until the ignition

timing line on the flywheel is aligned with the reference

line on the flywheel housing. This line is TDC (top dead

center). Refer to figure 4-29.

Figure 4-27. Breaker point gap.

(6) Install the dust shield rotor and distributor

cap.

b. Timing Distributor to Engine

(1) Loosen the screw at the distributor ad-

vance arm and set the pointer at 0 (fig.4-28).

Figure 4-29. Flywheel timing mark.

(3) If necessary, mark the flywheel and

housing with white chalk or paint.

(4) Connect a timing light as shown in figure

Figure 4-28. Distributor timing adjustment.

4-30