Figure 4-5. Governor exploded view.

TM 10-3930-621-34

e. Aline shifter lever holes with shaft holes and drive in

4-18. Assembly

shifter lever pins (fig. 4-4).

Refer to figure 4-5 and assemble as follows:

f. Rotate shifter lever (151 outward and slide in

a. Reassemble the governor internal parts assembly

governor internal parts assembly (fig. 4-3).

as follows:

g. Install surge adjusting spring (1)) and screw (2) in

(1) Install carrier (25) on shaft (24) and secure

end cover (6), securing it with locknut I(l).

with groove pin (19).

h. Using new gasket (7). install end cover (6) and

(2) Install weight shafts (27) on carrier (25) and

secure it with screws (3) and lock washers (41).

secure weights (18) on shafts with pins (26).

i. Install key (20) on shaft (24) and press on gear (21).

(3) Slide shifter (17) and thrust bearing (16), in

j. Drive in groove pin (23) holding gear to shaft.

that order, on carrier and secure with snap ring (13).

k. Install spring bracket (29) on housing with screw

(4) Install ball bearings (12) and press in new

(35), nut (32), and lock washers (13).

preformed packing on carrier shaft (24).

I. Check installation marks and in, stall adjusting nut

b. Install two roller bearings (9) in housing ( 11).

(30), screw (33), and spring (34) on bracket. Also using

c. Install shaft plug (8) and new oil seal (39) in

mark, position spring (in it r 1: 7.

housing.

d. Aline washer (38), control lever (37), and shifter

lever (15) and insert lever shaft (36).

4-9