Figure 3-69. Frame, guard. and seat, installed view.

Section XX. FRAME, GUARD, AND SEAT

(2) Remove two screws and nuts securing over-

3-77. Overhead Guard

head guard to front corners of truck.

a. Removal. Refer to figure 3-69 and remove the

(3) Carefully remove guard from truck.

overhead guard as follows:

(1) Remove two screws and nuts securing over-

head guard to supports on counterweight.

Figure 3-69. Frame, guard. and seat, installed view.

the same manner. Replace rubber grommets if grom-

b. Installation. Refer to figure 3-69 and install

mets are damaged or missing.

overhead guard on truck as follows:

c. Installation. Refer to figure 3-69 and install

(1) Carefully lift overhead guard into place on

side panels as follows:

truck.

(1) Install side panels in side of truck.

(2) Secure overhead guard to four supports on

(2) Secure side panels with latches.

corners of truck with four screws and nuts.

3-79. Operator's Seat

3-78. Side Panels

a. Removal. Lift rear of seat to clear pins. Slide

a. General. Ventilated side panels are mounted on

seat forward to disengage seat plate from flange.

either side of the seat plate. They help to supply air

Lift seat to rear and up to remove seat and plate

to the compartment are are easily removable to gain

from truck.

access to components in the compartment. Rubber

b. Disassembly. Disassemble seat as follows:

grommets in hand holes protect sharp edges.

(1) Remove seat cushion from lower part of seat.

b. Removal. Refer to figure 3-69 and remove the

(2) Remove two screws and lock washers securing

side panels as follows:

backrest cushion to seat frame.

(2) Disengage latch and remove side panel from

c. Assembly. Assemble seat as follows:

truck.

(1) Install backrest cushion on frame and secure

(2) Remove side panel from other side of truck in

3-59