OPERATION OF AUXILIARY EQUlPMENT.

1. Wash the unit frequently with clean, fresh

3-31.

OPERATION IN EXTREME

HEAT.

water. Do not contaminate hydraulic system or damage

temperatures of extreme heat:

electrical components.

1. Make certain that hydraulic reservoir is filled to

2. Coat exposed metal surfaces with dustproofing

proper level.

material. Remove rust immediately and apply paint or

2. Inspect lines and fittings for breaks or leaks.

oil as applicable.

3. Inspect and maintain battery electrolyte level.

3-35.

OPERATION OF AUXILIARY EQUlPMENT.

3-32.

OPERATION IN DUSTY OR SANDY AREAS.

To protect tile electric fork lift truck as much as possible

in these areas:

3-36.

FIRE EXTINGUISHER. (Dry Chemical Type)

The dry chemical type fire extinguisher is effective in

1. Shield the fork lift truck from dust and sand as

areas where ambient temperature is -25 deg F. and

much as possible when not in use. Take advantage of

above. If winterized (pressurized with nitrogen), the tire

natural barriers which offer protection from dust and

extinguisher may be used in temperatures below -25

sand.

deg F. Tile fire extinguisher is a 2-1/2 pound, stored

2. Check air filter frequently for clogged condition.

pressure, lever-operated extinguisher. To operate the

Wipe dust and dirt from filter area before removing from

fire extinguisher, proceed as; follows:

reservoir. Wipe dust and dirt from cylinders frequently

as sand arid dust acts as an abrasive and can damage

1. Disconnect clamp that secures extinguisher on

the lift cylinders.

mounting bracket, swing clamp open. and remove

3. Clean all lubrication points thoroughly before

extinguisher.

applying lubricants.

4. Wipe dust and dirt from all external areas

2. Hold extinguisher upright, aim nozzle at base

regularly.

of fire and raise operating lever.

3.33.

OPERATION UNDER RAINY OR HUMID

3. Direct discharge at base of fire with a side-to-

CONDITIONS. If unit is outside and not operating,

side sweeping motion.

protect it with a canvas or other waterproof covering.

CAUTION

Remove cover during dry periods. Keep hydraulic

reservoir full to avoid condensation. Wipe excess

moisture from external surfaces.

Weigh the fire extinguisher every 6 months.

Replace the extinguisher if the weight is less

3-34.

OPERATION IN SALT-WATER AREAS. In

than 4-1/2 pounds, or tile pressure is below 125

areas where salt water is a problem to the equipment:

pounds.

3-4