 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 8.
Release parking brake lever.
2.
Operate tilt control lever forward to bring mast
9.
Slowly back the truck away from tiered stack
assembly to vertical position.
until the forks are clear.
3.
Operate lift control lever to raise or lower
10. Operate lift control lever forward to lower
forks to proper height to pick up load.
forks into normal traveling position (8 to 10 inches
4.
Slowly move truck forward until forks are
above surface).
positioned directly under load. Make certain forks are
fully inserted in pallet or under load.
3-26.
DEPOSITING LOAD IN STORAGE AREA.
5.
Apply parking brake to prevent truck from
The load is placed in a level storage area as follows:
shifting position during lifting operation.
6.
Operate direction control lever to center-off
1.
Carefully drive up to position where load is to
position.
be deposited.
7.
Operate lift control lever to rear and raise load
2.
Depress brake pedal to halt truck.
approximately 12 inches above ground level and
3.
Apply parking brake.
release lever.
4.
Operate direction control lever to center-off
8.
Operate tilt control lever backward to tilt forks
position.
backward and release lever.
5.
Operate tilt control lever forward to bring the
mast assembly to the vertical position, and release
3-24.
MOVING LOAD. The load is transported in
lever.
the following manner:
6.
Operate lift control lever forward and carefully
lower load to ground. Continue to lower forks until free
1.
Operate direction control lever from center-off
from under load.
position to proper forward or backward position for
7.
Operate direction control lever to reverse
desired direction of travel.
position.
2.
Release the parking brake lever.
8.
Release parking brake lever.
3.
Slowly depress accelerator pedal, and move
9.
Slowly back truck away from deposited load.
the load to the desired location.
3-27.
BATTERY CARE.
WARNING
3-28.
Every 8 hours of after a day's work with the
The operator must be alert at all times while
truck, the operator must have the battery charged
operating the fork lift truck. Failure to observe
overnight for efficient operation of the fork lift truck the
this warning can result in serious injury or death
following day. Refer to TM 10-1690A for battery
to the operator or other personnel.
maintenance.
3-25.
DEPOSITING LOAD ON TIERED STACK.
3-29.
OPERATION
UNDER
UNUSUAL
The load is deposited on a tiered stack as follows:
CONDITIONS.
1.
Operate lift control lever to rear until load
height is above tier.
3-30.
OPERATION IN EXTREME COLD.
In
2.
Slowly drive truck forward until load is
temperatures below 0 deg F:
positioned directly over tier.
3.
Apply parking brake.
1.
See that hydraulic reservoir is filled to proper
4.
Operate direction control lever to center-off
level. (Refer to figure 2-1.) Inspect for leaks at all
position.
accessible lines, hoses and fittings.
5.
Operate tilt control lever forward to tilt load
2.
Inspect brakes for proper operation.
squarely over tier.
3.
Keep battery fully charged.
Maintain
6.
Operate lift control lever forward and carefully
electrolyte level.
lower load into position on tier. Continue to lower forks
4.
Be extremely careful when handling hoses,
until free of pallet.
lines, or wiring to avoid breakage.
7.
Operate direction control lever to reverse
5.
Wipe exposed areas dry with a clean cloth.
position.
3-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals