INSTALLATION OF CONTROL VALVE

TRANSMISSION

Figure 43.

transmission cover. These screws should be snug, not

tightened.

Install the two capscrews that go through the torque

converter housing horizontally into the valve. Run them

up tight.

Tighten the six Allen head capscrews, drawing them up

slowly and evenly. Torque them to 20 lb./ft. with

lubricant.

SHIFTING LEVER ADJUSTMENT

With the directional spool in neutral position, adjust the

linkage so the shifting lever is in a vertical position.

Figure 44.

BRAKE AND INCHING LINKAGE

ADJUSTMENT (Fig. 45)

INSTALLATION OF CONTROL VALVE

1. Adjust brakes by turning adjusting screw through

IMPORTANT:

Always use new factory gaskets,

the backing plate at the drive wheels until shoes are

because they are made of a special non-shrinking

within one notch of dragging.

material.

Install the valve and porting plate with the Allen head

capscrews that go through vertically into the

B-110