SECTION I INTRODUCTION

TM 10-3930-253-20P

SECTION I

INTRODUCTION

Applied to assemblies which are not procures

Scope

or stocked as such, but are made up of two

This manual lists repair parts, required for the

or more units, each of which carry

performance of organizational maintenance of the lift

individual stock numbers and descriptions

truck.

and are procured and stocked and can be

assembled

units

indicated

General

maintenance categories.

a. The Repair Parts List is arranged as follows:

Applied to parts and assemblies which are not

(1) Individual parts and major assemblies are

procured or stocked, the mortality of which

listed alphabetically by item name within the numbered

is normally below that of the applicable end

functional groups.

item, and the failure of which should result

(2) Assembly

components

and

in retirement of the end item from the

subassemblies are indented and listed alphabetically by

supply system.

item name under major assemblies.

Applied to repair parts which are not procured

b. This Repair Parts and Special Tools List is

or stocked, the requirement for which will

divided into the following sections:

be supplied by use of the next higher

(1) Prescribed Load Allowance (PLA) -

assembly or components.

Section II.

A consolidated listing of repair parts

Applied to repair parts which are not stocked.

quantitatively allocated for initial stockage at the

The indicated maintenance category

organizational level. This is a mandatory stockage

requiring such repair parts will attempt to

allowance.

obtain them through cannibalization; if not

obtainable through cannibalization, such

(2) Special

Tools,

test

and

Support

repair parts will be requisitioned with

Equipment - Section III. A list of special tools, test and

supporting justification through normal

support equipment authorized for the performance of

supply channels.

maintenance at the organizational level. (Not

Applied to repair parts authorized for local

applicable.)

procurement. If not obtainable through

(3) Repair Parts - Section IV. A list of repair

local procurement, such repair parts will be

parts authorized for the performance of maintenance at

requisitioned through normal supply

the organizational level.

channels with a supporting statement of

(4) Federal Stock Number and Reference

non-availability from local procurement.

Number Indexes - Section V. A list of Federal stock

Applied to major assemblies that are procured

numbers followed by reference numbers in ascending

with PEAM (Procurement Equipment

alphanumeric sequence, cross referenced to index

Missile Army) funds for initial issue only to

number.

be used as exchange assemblies at DSU

and GSU maintenance level.

These

Explanation of Columns

assemblies will be stocked above DSU and

The following provides an explanation of columns in the

GSU or returned to depot supply level.

tabular lists in Sections II, III, and IV;

a. Source, Maintenance and Recoverability Codes.

NOTE

(SMR).

Source code is not shown on

(1) Source code indicates the selection status

common hardware items known to

and source for the listed item. Source codes are:

be readily available in Army supply

channels

and

through

local

Code

Explanation

procurement.

Applied to major repair parts which are

stocked in or supplied from DSA/GSA or

(2)

Maintenance Code indicates the lowest

Army supply system, and authorized for

category of maintenance authorized to install the listed

use at indicated maintenance categories.

item. The maintenance level code is:

Applied to repair parts which are not procured

or stocked, but are to be manufactured at

Code

Explanation

indicated maintenance categories.

Organizational maintenance

iii