Install Cylinder Head

(f) Thread the valve spring compressor

adaptor into a rocker shaft bolt hole in the cylinder

head. Apply pressure to the end of the valve spring

compressor handle to compress the valve spring

(fig. 3-42). Remove the two-piece tapered spring

(g) Release tool and remove the valve spring

cap, valve spring and valve seat.

(2) To remove the exhaust valve spring with

the cylinder head, removed from the engine, use the

following procedure:

(a) Support the cylinder head on wood

blocks 2 inches above the work bench to keep the

cam followers clear of the bench.

(b) Remove the fuel lines from the injector

and fuel connectors (para 3-13).

(c) Remove the two bolts holding the rocker

arm shaft bracket to the cylinder head and remove

the bracket from the-shaft (para 3-13).

(d) Remove the fuel injectors (para 3-14).

(e) Remove the exhaust valve spring from

the cylinder head as previously outlined above. In

addition, use a block of wood under the cylinder

head to support the exhaust valve.

(f) Remove the cam followers and push rod