Transmission Linkage and Levers

4-71. Transmission Linkage and Levers

a. General. Check all linkage between operator's

controls and transmission frequently. Remove

console panel cover (fig. 4-36) and inspect the

linkage for proper lubrication, cleanliness, wear,

damage and freedom of operation.

(1) Range selector linkage (low, med., high).

Make sure operator's control (fig. 2-1) is positioned

t o correspond exactly with the detent positions of

range selector valve. If out of adjustment, report to

direct support maintenance.

(2) Forward and reverse linkage. Make sure

operator's controls (fig. 2-1) correspond exactly

w i t h valve selector detents. If out of adjustment,

report to direct support maintenance.

b . Removal. Refer to figure 4-39 and remove the

t r a n s m i s s i o n linkage and levers.

c. Installation. Refer to figure 4-39 and install

t h e transmission linkage and levers.

Adjustment.

Refer

TM10-3930-243-34

for

adjustment

procedures.