 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 10-3930-242-34
3 - 1 7 . Fuel Tank
a. General. The fuel tank is located on the
r i g h t side of forklift opposite the driver's seat.
The fuel tank is made from a heavy gage metal
a n d access steps are made on the fuel tank.
b. Removal.
(1) Remove toolbox (fig. 3-37).
(2) Remove console side panel (fig. 3-37).
(3) Remove plug from fuel tank (17, fig.
( 4 ) For easier access to the fuel lines and
mounting hardware, raise extension boom to
" f u l l up" position and install the extension sup-
ports.
(5) Remove fuel lines from fuel tank elbows
(9 and 11, fig. 3-38).
( 6 ) Remove mounting nuts and screws (fig.
a s s e m b l e the fuel tank.
d. Cleaning and Inspection.
(1) Clean the fuel tank thoroughly, using
s t e a m cleaning as the preferred method.
WARNING
Before attempting to weld or braze the
f u e l tank, steam clean the tank for a
minimum of eight (8) hours. Remove fuel
cap and open the discharge and return
lines during the welding process. Failure
to observe this warning may result in
serious injury or death.
(2) Inspect for cracks, breaks, and dents.
(3) Repair or replace the fuel tank, as
necessary.
s e m b l e the fuel tank.
f.
Installation.
(1) Install the plug (10, fig. 3-38) in the fuel
tank (17).
(2) Secure the fuel tank (fig, 3-37).
( 3 ) Connect the fuel lines at the fuel tank
elbows (9, and 11, fig. 3-38).
( 4 ) Install the console side panel and tool-
box (fig. 3-37).
(1) Remove caps from fuel lines.
(5) Fill the fuel tank (TM 10-3930-242-12).
(2) Install
(TM
pump
the
fuel
(6) If wanted, lower the extension boom and
10-3930-242-12).
remove the extension supports.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals