LUBRICATION ORDER - LO-10-3930-664-120001

LUBRICATION ORDER

LO 10-3930-664-12

19 1994

TRUCK, FORKLIFT, DED, PNEUMATIC TIRE. ROUGH TERRAIN,

4000 POUND CAPACITY

MODEL MHE - 270 (NSN 3930-01-330-8907)

MODEL MHE - 271 (NSN 3930-01-330-8906)

Reference: TM 10-3930-664-10, TM 10-3930-664-24, TB 43-0210, and Supply Catalog C9100-IL

REPORTING ERRORS AND RECOMMENDING IMPROVEMENTS

You can help improve this manual. If you find any mistakes, or if you know a way to improve the

procedures, please let us know. Mail your letter or DA Form 2028 (recommended changes to

publications and blank forms) directly to: Commander, U.S. Army Tank-Automotive Command,

ATTN: AMSTA-MMAA, Warren, MI. 48397-5000. A reply will be sent directly to you.

DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.

This lubrication order is divided into two sections, based on lubrication intervals (hardtime and on-condition)

A dotted leader line (- - - -) means there are lubrication points on both sides of the vehicle.

Intervals are based on normal operation.

Lubricate more often during constant operation.

Relubricate all items found contaminated after fording, swimming, or high-pressure washing.

On-condition intervals for oil changes shall be determined by the Army Oil Analysis Program (AOAP)

laboratory and shall be applied unless otherwise notified. If AOAP cannot be performed then hardtime

intervals specified in notes should be used.

Oil filters shall be changed at prescribed hardtime intervals or sooner when:

a. They are known to be contaminated, or clogged;

b. Services is recommended by AOAP laboratory analysis

For equipment under manufacturer's warranty, hardtime oil service intervals shall be followed. Intervals shall

be shortened if lubricants are known to be contaminated or if operation is under adverse conditions (such as

linger-than-usual operating hours, extended idling periods, extreme dust).

WARNING: Dycleaning solvent (SD-2) is toxic and flammable. Wear protective goggles and gloves,

and use only in well-ventilated area. Avoid contact with skin, eyes, and clothes, and do not use near

open flame or excessive heat. If you become dizzy while using drycleaning solvent, get fresh air

immediately, and get medical aid. If contact with skin or clothing is made, flush with water. If contact

with eyes is made, wash your eyes with water, and get medical aid immediately.

For operation of vehicle in prolonged cold temperature below -10F(-23C): remove lubricants prescribed in

the key for temperatures above -10F (-23C), clean parts with drycleaning solvent (SD-2), and relubricate with

lubricants specified in the key temperature -10F to -65F (-23C to -54C).

Operation in dusty or sandy areas require more frequent cleaning and servicing of filters to prevent dust from

entering engine, transmission, steer unit, and hydraulic system.

MAN-HOUR TIMES

The man-hour time specified is the time you need to do all the services prescribed for a particular interval. There

times are based on normal vehicle operation.

LEVEL OF MAINTENANCE:

C---Operator

O---Unit Maintenance

OBSERVE THE FOLLOWING:

NEVER use the wrong type grease.

NEVER use too much lubrication

ALWAYS clean grease fittings with drycleaning solvent (SD), type II or equivalent, and

dry before lubricating.

ALWAYS use the lubrication order

Approved for public release: distribution is unlimited.

Card 1 of 6