 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 LO 10-3930-643-12
LUBRICATION ORDER
Repeat procedure for the other
Three drive shafts, two with three
fittings, one with two fittings.
reservoir. Install front side access
covers.
The torque converter to trans-
a.
has a
mission
drive
shaft
If fluid level is low, check for and
pressure
fitting in each spider (32 and
leaks
at
correct
33) and one in the slip tube
reservoirs,
fluid
lines, and brake calipers. Fluid
(34).
level may also be low due to air in
b. The transmission to rear axle
the hydraulic lines. If so, bleed
the lines
as described in TM
drive shaft has a fitting in
each spider (32 and 33) and one
10-3930-643-20.
in the slip tube (34).
Note 15.
BOOM PIVOTS
The support bearing to front
c.
axle drive shaft has a fitting
Apply lubricant to two fittings (30)
in the slip tube (34) and one at
(only one shown) until clean lubri-
spider (32).
cant appears.
Apply lubricant to all fittings
until clean lubricant appears.
Note 16. DRIVE SHAFT (TRANSMISSION
TO SUPPORT BEARING)
Fittings are located in the end of
the drive shaft in the spider and in
the slip tube.
Apply lubricant to both fittings
(31) until clean lubricant appears.
NOTE
Perform the following lubrica-
tion procedure each quarter.
Card 13 of 17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals