 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 LO 10-3930-643-12
LUBRICATION ORDER
is on the axle housing.
The following conditions will be
observed
BEFORE
any
performing
The model has only one service
lubrication task, unless otherwise 2.
brake reservoir.
specified:
3.
See LUBRICATION SPECIFICATIONS
1.
Review the Lubrication Order
before performing procedure and
for type of brake fluid used.
it as a guide during
use
procedure.
2.
All tasks are two-man proced-
ures. To ensure the safety of
the man performing lubrication,
the operator will remain at the
controls during procedure.
Oil
fluid must
3.
and
be at
before
temperature
operating
levels are checked. Exercise
forklift hydraulic systems to
warm fluid.
S/N 2001 AND ABOVE
4. Unless specified by a procedure,
This model has a one-piece axle.
forks must be lowered to the
1.
The filler and level plug is on
ground to ensure that the fork-
the spindle of the axle housing.
lift is immobile.
2. This model has two service brake
5.
Forklift must be parked on level
reservoirs.
ground before checking oil or
fluid levels. Failure-to do so
3.
See LUBRICATION SPECIFICATIONS
result in an incorrect
will
for type of brake fluid used.
reading.
4.
This model has an engine oil
Parking brake must be applied.
6.
sample valve.
7.
Transmission must be in neutral.
8.
Unless specified by a procedure,
engine must be shut off.
9.
Disconnect switch must be off.
MODEL DIFFERENCES
S/N 2000 AND BELOW
1.
This model has a three-piece
axle. The filler and level-plug
Card 7 of 17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals