FOR OPERATION OF EQUIPMENT IN PROTRACTED COLD TEMPERATURES BELOW-15F (-260C)

NOTES:

FOR OPERATION OF EQUIPMENT IN

8. TRANSMISSION AND CONVERTER OIL FILTER.

PROTRACTED COLD TEMPERATURES BELOW-15F

Each 500 hours, remove filter element, clean filter

(-260C). Remove lubricants prescribed in Key for

housing, install new filter element and gasket. After

temperatures above -150F (-260C). Relubricate with

replacement, with engine running at idle speed, oil at

lubricants specified in Key for temperatures below -150F

operating temperature and transmission in neutral, add

(-260C). If OEA lubricant is required to meet the

oil to bring oil level to "FULL" mark. Operate for 5

temperature ranges prescribed in the Key, OEA lubricant

minutes and check filter housing for leaks.

is to be used in place of OE/HDO-10 lubricant for all

temperature ranges where OE/HDO-10 is specified in the

9. TRANSMISSION AND CONVERTER. Check level

Key.

each 50 hours with engine running at idle speed, oil at

operating temperature, and transmission in neutral.

2. OIL CAN POINTS. Each 250 hours, lubricate shift

Maintain oil level at "FULL" mark. Each 1000 hours drain

linkage, control valve linkage, brake linkage, and all other

transmission and converter. Gain access to converter

oil can points with OE/HDO.

drain plug through timing gear opening on engine

flywheel housing. Rotate flywheel until drain plug is in

3. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold

opening. Remove filter element, clean filter housing,

engine, oil level should be at high mark on dipstick. Hot

install new filter element and gasket. Fill transmission to

engine, oil level must be between high and low marks on

low mark. Run engine at idle speed to fill converter and

dipstick (allow to set 5 minutes before checking).

lines. With engine running at idle speed, oil at operating

temperature and transmission in neutral, add oil to bring

4. ENGINE. Oil is to be changed each

oil level to "FULL" mark. Operate for 5 minutes and

250 hours. Drain when lubricant is warm.

check for leaks.

5. ENGINE OIL FILTER. Each 250 hours, remove filter

10.

HYDRAULIC SYSTEM AND HYDRAULIC

element, clean housing and install new filter element.

RESERVOIR FILTER. Each 1000 hours, drain the

After installing new filter element, fill crankcase, operate

hydraulic system, remove filter element, clean filter shell,

engine for 5 minutes, check housing for leaks, check

install new filter element and gasket. Clean fill cap. Fill

crankcase oil level and bring to "FULL" mark.

hydraulic reservoir, operate equipment for 5 minutes,

check for leaks, check oil level and bring to "FULL" mark.

6. AIR CLEANER. Each 10 hours, refill reservoir to level

mark. Each 100 hours disassemble entire unit, clean, re-

11. WHEEL BEARINGS. Each 1000 hours, remove

oil and assemble.

wheels, clean and inspect all parts, replace damaged or

worn parts, repack bearings, and assemble.

7. DISTRIBUTOR. Each 500 hours, lubricate rotor

wick with 3 or 4 drops of OE/HDO. Apply very light coat

of GAA to breaker cam.

TA 220169

LO 10-3930-624-12

CARD 6 OF 7