TRANSMISSION AND CONVERTER OIL FILTER.

NOTES CONTINUED:

14. HYDRAULIC RESERVOIR. Each 50 hours check

level. Each 1000 hours drain, flush and refill reservoir,

converter drain plugs and drain. Access to converter

operate hydraulic system for 5 minutes, check for leaks,

drain plug is gained through timing cover opening on

check level and bring to "FULL" mark.

engine flywheel housing. Rotate flywheel until drain plug

is in opening, remove plug and rotate flywheel until plug

15. LUBRICANTS. The following is a list of lubricants

opening is aligned with drain opening at bottom of

with military symbols and applicable specification

flywheel housing. Drain when lubricant is warm. Fill

numbers.

transmission to low mark. Run engine at idle speed to fill

converter and lines. With engine running at idle speed,

OE/HDO

MIL-L-2104

oil at operating temperature and transmission in neutral,

MIL-L-2105 GAA

add oil to bring oil level to "FULL" mark. Operate for 5

MIL-G-10924 OEA

MIL-L-46167

minutes and check for leaks.

BFS

MIL-B-46176

(SD), Type II

P-D-680

9. TRANSMISSION AND CONVERTER OIL FILTER.

Each 500 hours, remove filter element, clean filter

housing and install new filter element and seal. fill

transmission to low mark. With engine running at idle

speed, oil at operating temperature and transmission in

neutral, add oil to bring oil level to "FULL" mark. Operate

for 5 minutes and check filter housing for leaks.

10. WHEEL BEARINGS. Each 1000 hours, remove

wheels, clean and inspect all parts, replace damaged or

Copy of this Lubrication Order will remain with the

worn parts, repack bearings, and assemble.

equipment at all times, instructions contained herein are

mandatory.

11. DIFFERENTIAL. Check level each 250 hours.

Change gear lubricant only when required by

By order of the Secretary of the Army:

maintenance repair action, contamination by water, or

other foreign material. After refill, operate for five

JOHN A. WICKHAM, JR.

minutes, check for leaks and bring oil level to level plug

General, United States Army

opening.

Chief of Staff

12. UNIVERSAL JOINT. Each 500 hours, remove joint,

OFFICIAL:

disassemble, clean and inspect all parts, replace

ROBERT M. JOYCE

damaged or worn parts, repack bearings and assemble.

Major General, United States Army

The Adjutant General

13. HYDRAULIC OIL FILTER. Each 500 hours, remove

DISTRIBUTION:

element, clean filter shell and install new element. After

To be distributed in accordance with DA Form 12-25A,

replacement, operate hydraulic system for 5 minutes,

Operator

and

Organizational

maintenance

check for leaks, check level and bring to "FULL" mark.

requirements for Warehouse Equipment.

U.S. GOVERNMENT PRINTING OFFICE: 1984-420-903/249

LO 10-3930-606-12

Card 6 of 6