EXPECTED TEMPERATURE - LO-10-3930-606-120005

5. ENGINE OIL FILTER. Each 250 hours, remove filter

NOTE

element, clean housing and install new filter element.

After installing new filter element, fill crankcase, operate

FOR

OPERATION

EQUIPMENT

engine for 5 minutes, check housing for leaks, check

PROTRACTED COLD TEMPERATURES BELOW -

crankcase oil level and bring to "FULL" mark.

150F (-260C). Remove lubricants prescribed in Key for

6. AIR CLEANER. Each 10 hours, refill reservoir to level

temperatures above -150F (-260C). Relubricate with

mark. Each 100 hours disassemble entire unit, clean, re-

lubricants specified in Key for temperatures below -150F

oil and assemble.

(-260C). If OEA lubricant is required to meet the

7. DISTRIBUTOR. Each 500 hours, remove filter plug

temperature ranges prescribed in the Key, OEA lubricant

from side of drive shaft housing and add OE/HDO-10 as

is to be used in place of OE/HDO-10 lubricant for all

necessary to bring level to filter plug opening. Lubricate

temperature ranges where OEIHDO-10 is specified in the

rotor wick with 3 or 4 drops of OE/HDO-10. Apply very

Key.

light coat of GAA to breaker cam.

2. OIL CAN POINTS. Each 250 hours, lubricate shift

8. TRANSMISSION AND TORQUE CONVERTER.

linkage, control valve linkage, brake linkage, and all other

Check level each 50 hours with engine running, oil at

oil can points with OE/HDO.

operating temperature and transmission in neutral.

3. ENGINE OIL LEVEL HOT OR COLD CHECK. Cold

Maintain oil level at "FULL" mark. Each 1000 hours

engine, oil level should be at high mark on dipstick. Hot

remove transmission and

engine, oil level must be between high and low marks on

dipstick (allow to set 5 minutes before checking).

TA220582

4. ENGINE. Oil is to be changed each 250 hours. Drain

when lubricant is warm.

LO 10-3930-606-12

CARD 5 OF 6