 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 NOTES
1.
FOR OPERATION OF EQUIPMENT IN
6.
TRANSMISSION,
BREATHER
AND
OIL
PROTRACTED COLD TEMPERATURES BELOW150F
FILTER. Check oil level each 50 operating hours, with
(260C).
Remove lubricants prescribed in Key for
engine running at idle speed,
oil at operating
temperatures above 150F (260C). Relubricate with
temperature and transmission in neutral. Maintain oil
lubricants specified in Key for temperatures below 150F
level at "FULL" mark on bayonet gage. Clean breather in
(260C). If OEA lubricant is required to meet the
dry cleaning solvent. Each 6 months or each 500
temperature ranges prescribed in the Key, OEA lubricant
operating hours,
whichever occurs first, drain the
is to be used in place of OEIHDO10 lubricant for all
transmission and converter. Remove filter element,
temperature ranges where OE/HDO10 is specified in the
clean filter housing and install new filter element. Refill
Key.
transmission to low mark. With engine at idle speed, oil
at operating temperature, and transmission in neutral (to
2.
OIL CAN POINTS. Each 250 operating hours
fill lines and converter) add oil to bring to "FULL" mark on
lubricate accelerator linkage, rod ends, hinges and other
bayonet gage. Operate for 5 minutes and check for
friction points with OE/HDO.
leaks.
3.
ENGINE OIL LEVEL HOT OR COLD CHECK.
7.
AIR CLEANER. Each 250 operating hours
Cold engine, oil level should be at high mark on dipstick.
disassemble entire unit, clean, refill and assemble.
Hot engine, oil level must be between high and low
marks on dipstick (allow to set 5 minutes before
checking).
8.
LIFT CHAINS.
Each 250 operating hours
remove, soak and wash in dry cleaning solvent, drain
4.
ENGINE CRANKCASE DRAIN AND ENGINE
and dry. Soak in OEIHDO, drain and wipe outer surface
OIL FILTER. Each 250 operating hours drain crankcase,
of chains.
remove filter element, clean filter housing and Install new
filter element and gasket. After installing new filter
9.
DRIVE AXLE. Each 250 operating hours check
element, refill crankcase, operate engine for 5 minutes,
level at level plug opening.
check for leaks, check crankcase oil level and bring to
Change gear lubricant only when required by
"FULL" mark on dipstick.
maintenance repair action, contamination by water, or
other foreign material.
5.
DRIVE AND REAR WHEEL BEARINGS.
After refill, operate for 5 minutes, check for leaks and
Each 1000 operating hours remove wheels, clean and
bring oil level to level plug
inspect all parts, replace damaged or worn parts, repack
opening.
and
assemble.
TA220719
LO 10-3930-222-12
CARD 5 OF 6
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals