7-6. TRANSMISSION OUTPUT SHAFT REPLACEMENT/REPAIR/ADJUSTMENT (CONT)
If a new yoke was installed, adjust shims
(3) to obtain 0.005 in. (0.127 mm) gap
between yoke (5) face and washer (2).
Check and adjust output shaft (6) end play.
Install a dial indicator to read shaft
Pull up on output shaft (6) and read
end play on dial indicator.
If end play is not within 0.000 -
0.004 in. (0.000 - 0.1016 mm),
adjust shims (3) as necessary to
bring end play within specifications.
Remove indicator and base.
· Install front and rear propeller shafts (TM 10-3930-673-20).
· Fill transmission with oil (TM 10-3930-673-20).
END OF TASK