TRANSMISSION OUTPUT SHAFT REPLACEMENT/REPAIR/ADJUSTMENT - continued

TM 10-3930-673-34

(3)

Position output shaft (6) into transmission (7) and hold yoke end of output shaft in place using spacer

screws.

(4)

Install bearing cone (24), thrust washer (23) and retaining ring (22) over splined end of output shaft (6) and

seat bearing cone into bearing cup (18).

WARNING

Use care when installing snap and retaining rings. Snap and retaining rings are under spring tension

and can act as projectiles when released causing severe eye injury.

(5)

Install new retaining ring (22) to output shaft (6).

(6)

Lower transmission (7) to horizontal position with splines of output shaft (6) facing upward.

(7)

Position new large preformed packing (21) and shims (20) to top surface of transmission (7).

(8)

Press bearing cup (18) and new seal (19) into output cap (8).

(9)

Install plug (17) and plug (16) into output cap (8).

(10) Install oil baffle pan (14) to output cap (8) with two screws (15).

NOTE

Position bearing cone on top surface of spur gear as spur gear is placed horizontally into oil baffle pan.

(11) Position output cap (8) over transmission (7) and position spur gear (12) and bearing cone (13) over splines

of output shaft (6).

(12) Install output cap (8) to transmission (7).

(13) Loosely install two nuts (10) to two studs (11) and loosely install two screws (9). Tighten nuts and screws

alternately and evenly until fully tightened.

(14) Remove spacer screws from yoke of output shaft (6).

(15) Raise transmission (7) to vertical position and ensure that output shaft (6) rotates freely.

(16) Install yoke (5), new preformed packing (4), shims (3), washer (2), and screw (1) to output shaft (6).

Change 1

7-53