TRANSMISSION FRONT COVER REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

(b)

Install oil seal (11) in bearing retainer (10).

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and are

harmful to skin and clothing. To avoid injury or death, keep away from open fire and use in a well-

ventilated area. If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately

with soap and water.

(c)

Apply Permatex gasket material to bearing retainer (10). Ensure that oil seal (11) is on the outside before

installing bearing retainer. Install bearing retainer and seven screws (9) on front cover (1).

f. Installation.

(1)

Install front cover assembly (1) on main case

(7).

(a)

Ensure that two locator bushings are in

position on main case (7). The locator

bushings align front cover assembly (1)

with main case.

(b)

Place gasket (8) on main case (7).

(c)

Using suitable lifting device, lift front

cover assembly (1) and place it on main

case (7).

(d)

It may be necessary to rotate input shaft

(17) slightly to line up gear teeth in front

cover clutch packs.

(2)

Install four screws (6), three screws (5), and

screws (2, 3, and 4). Tighten screws to 50 lb-ft

TR00229

(67.8 Nm).

NOTE

Follow-on Maintenance:

Install transmission oil pump (Para 7-10).

Install torque converter (Para 7-3).

Install transmission control valve (Para 7-9).

Install transmission assembly (Para 7-4).

END OF TASK

7-49