Quantcast HYDRAULIC OIL SAMPLING VALVE REPLACEMENT - TM-10-3930-673-20-20685

 

Click here to make tpub.com your Home Page

Page Title: HYDRAULIC OIL SAMPLING VALVE REPLACEMENT
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
Installation - TM-10-3930-673-20-20684
Up
TM-10-3930-673-20-2 All Terrain Lifter Army System (ATLAS) 10 000 lb Capacity Manual
Next
Installation - TM-10-3930-673-20-20686
TM 10-3930-673-20-2
16
18-27. HYDRAULIC OIL SAMPLING VALVE REPLACEMENT
This Task Covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Condition
Tools and Special Tools
Engine OFF and cool (TM 10-3930-673-10)
Tool Kit, General Mechanic's: Automotive
Transmission cover removed (Para 16-5)
(Item 18, Appendix F)
Cap and Plug Set (Item 3, Appendix F)
Materials/Parts
Compound, Sealing (Item 32, Appendix C)
Rags (Item 26, Appendix C)
WARNING
Hydraulic oil in system can be under pressures over 3000 psi (20685 kPa) with engine OFF.
ALWAYS relieve pressure in hydraulic hoses before attempting to remove any component in
hydraulic system. With engine OFF, starter switch in RUN position, and attachment on ground,
move control levers through all operating positions several times to relieve hydraulic pressure.
Relieve pressure in hydraulic oil tank by loosening filler cap very slowly. Failure to follow these
precautions could result in serious injury or death to personnel.
At operating temperatures, hydraulic oil is hot and under pressure. Hot oil can cause injury to
personnel. Allow hydraulic oil to cool before disconnecting any hydraulic hoses.
CAUTION
Wipe area clean around all hydraulic connections to be opened during removal and disassembly. Cap
oil hoses and plug holes. Contamination of hydraulic system could result in equipment failure.
NOTE
Use suitable container to catch any hydraulic oil that may drain from system.
Remove caps and plugs as hoses are installed. Wipe all sealing surfaces on hydraulic components
and hoses clean and dry. Apply light coating of clean hydraulic oil to all seals as installed.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business