CRANKSHAFT MAIN BEARINGS MAINTENANCE - CONTINUED
INSTALLATION - CONTINUED
Install bearing halves dry for the following clearance checks.
Refer to end play data measured earlier in Removal. If
crankshaft end play is not within 0.005 to 0.010 in.
(0.127 to 0.254 mm), install a new, appropriate over-
size thrust bearing (5).
Install a dry upper main bearing half (3) over the
crankshaft journal such that the bearing tab will fit
into the notch in cylinder block. If used main bearing
is being installed, install upper bearing half in the
same position it was removed from.