 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 STEP 14.
Install the pump drive gear, the
two washers and the nut onto the
Tighten
pump drive gear shaft.
the nut snug and align
slot in
the nut with the hole in the pump.
Install cotter pin.
STEP 15.
Rotate the shaft to distribute
the oil.
Shaft should rotate
with the help of a short wrench
(Max. torque 100 pound-inches).
STEP 16.
Install the pump into its position
in the front end cover of the
engine and install the fasteners
that mount the pump (Refer to
page 7-73).
STEP 17.
Install the flanges around the
pump inlet tube and install a
new O-ring (Item 31.010) into
the flange.
(Refer to page
7-82).
STEP 18.
Install pump inlet tube (Item
31.008) onto the pump and
install the flange fasteners
(Item 31.012 and 90.775). (Refer
to page 7-82)
STEP 19.
Install the pump inlet hose
(Item 31.006) onto the tube
(Item 31.008) and tighten
clamp (Item 31.007) (Refer
to page 7-82).
STEP 20.
Remove cap from hydraulic line
(Item 31.018) and install line
onto the pump outlet fitting
(Item 31.014) (Refer to 7-82).
CAUTION
WHEN PUMP IS REINSTALLED, ALLOW
TO RUN FOR 2 TO 3 MINUTES BEFORE
PRESSURIZING.
TRY TO APPLY PRES-
SURE GRADUALLY FOR THE NEXT 5
MINUTES BUT DO NOT PRESSURIZE FOR
MORE THAN 5 SECONDS AT A TIME.
5-92G
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals