Table 1-1. General Torques

Overall width ........................ 46 inches

(19) Distributor

Underclearance (at mast) ..... 3 inches

Manufacturer........................ Delco-Remy

(23) Performance

Manufacturer part number .... 1112461

Maximum speed (forward ..... 108 mph

(20) Tilt cylinder

and reverse)

Manufacturer........................ Allis-Chalmers

Lifting speed:

Manufacturer part number .... 4825960

..... Loaded

43 fpm

Type..................................... Single stage

..... Empty

45 fpm

Forward tilt ........................... 3 degrees

Lowering speed:

Backward tilt ........................ 8 degrees

..... Loaded

70 fpm

(21) Lift cylinder

..... Empty

70 fpm

Manufacturer........................ Allis-Chalmers

Lift height ............................. 180 inches

Manufacturer part number .... 4824436 (primary)

Free lift ................................ 51 3/4inches

4824437 (secondary)

Load capacity ....................... 6000 lb

Type..................................... High free lift

Load center .......................... 24 inches

(22) Dimensions and weight

Forward mast tilt .................. 3

Height:

Backward mast tilt ................ 8

With uprights extended .. 229Y4 inches

Turning radius ...................... 891/2 inches

With uprights retracted... 83 inches

Basic aisle for right angle ..... 156 inches

Length:

stacking

With forks ..................... 138 inches

Less Forks .................... 98 inches

(24) Torque data. Refer to table 1-1

Weight ........................... 10,350 pounds

Wheelbase..................... 55 inches

Table 1-1. General Torques

Bolt size

Grade 5

Grade 8

(inches)

Minimum

Maximum

Minimum

Maximum

1/4

5/16

20.5

3/8

7/16

1 /2

110

132

9/16

110

132

160

192

5/8

150

180

220

264

3/4

270

324

380

456

7/8

400

480

600

720

580

696

900

1080

1-1/8

800

880

1280

1440

1-1/ 4

1120

1240

1820

2000

1-3/8

1460

1680

2380

2720

1-1/2

1940

2200

3160

3560

Note. These values apply to fasteners as received from supplier, and when lubricated with normal engine oil. They

do not apply if special graphited or moly-disulphide greases or other extreme pressure lubricants are used. This applies

to both UNF and UNC threads.

1-4